Bootstrap Framework 3.3.6

[Brandon]

Hello,

I have used the auto install on my server and I was able to get the bot to join but the web page that is listed will not work.

Any ideas?

[Crypto90]

Which operating system are you using on your server?
CenotOS for example has IpTables firewall running by default and you need to open the TCP port for the webinterface.

Example command to open TCP port 8080:

Code: Select all

iptables -A INPUT -p tcp -m tcp --dport 8080 -j ACCEPT

The Webinstaller starts with 8081.

[Brandon]

I'm running CentOS 7 64bit

How do I go about doing this?

[Crypto90]

In your case connect to your centos server with SSH and use the following command:

Code: Select all

iptables -A INPUT -p tcp -m tcp --dport 8081 -j ACCEPT

[Brandon]

I have done that and the next line says reply?

[Crypto90]

In CentOS 7 you can also use the two commands:

Code: Select all

firewall-cmd --permanent --add-port=8081/tcp
firewall-cmd --reload

After that your webinterface should be accessable.

[Brandon]

So you do these commands in order?:

iptables -A INPUT -p tcp -m tcp --dport 8081 -j ACCEPT
firewall-cmd --permanent --add-port=8081/tcp
firewall-cmd --reload

[Crypto90]

The first command alone and the second and third command does basically the same.

Code: Select all

iptables -A INPUT -p tcp -m tcp --dport 8081 -j ACCEPT

Just opens the port, if you reboot your server the port is closed again.

Code: Select all

firewall-cmd --permanent --add-port=8081/tcp
firewall-cmd --reload

Does open the port too and also save it permanently, so after a server reboot the port is still open.

Use one of the both solutions, for the second case, use them in the order.

[Brandon]

Ok, because these say error when I do them:

firewall-cmd --permanent --add-port=8081/tcp
firewall-cmd --reload

Should I restart the box or should it work?

[Crypto90]

What kind of error?
There should not be any error, can you send me your error?
You don't need to reboot your server.